on computer
- Boot PI with SD card --- here you need ethernet cable to download the system
- Boot in... board working. WIFI - not working. Here you again need ethernet cable attached and need to download under "Programs" the "Networking Tool" addon. Installed th... m that may come - complete HDMI turned off - then need additional line in config.txt
hdmi_force_hotplu
Capacitor charged, then discharge). For this you need a TC54**VC** [[beam.components| component]]
As I... ergy to drive the motor, the trigger voltage will need to be higher than the 0.7V set by a single diode:... t current is leaking at close to trigger point => need to have reasonably high light level to quickly go
=GETHISTORY("PETR4.SA",1,TODAY()-1)
(you might need to use semicolons instead of commas) and then pre... ay can be done with the INDEX function. You don't need to use ctrl+shift+enter for it to work as it does