dically and also has high packet loss.
Followed some instructions at www.xors.me/?p=1069 to install some driver - but I still have problems
Seeing some strange loop for wlan running in syslog
<code>
Dec 26... presumably crashes out every so often because of some small variation in Wifi signal strength and then
I get the same "Mode not supported" error. After some googling, came accross someone advising adding 2 lines to "config.txt":
hdmi_group=2
hdmi_mode=85
... at which point it turns of the HDMI audio out for some reason. Adding line to config.txt to force it to
x behaviours. The approach taken here is to mimic some of this complex behaviour using a minimal set of ... ng out this behaviour from future interactions.
Some type of "self healing" fuse, i.e. a fuse that can blow and then short itself again after some time interval, could be used to add adaptability